230 V Light Output Connection; Installing The External Release System Model Ks200Kit; Diagnostics And Device Signals; Photocell Signals - Nice Filo Instructions And Warnings For Installation

9.8 - CONNECTING THE 230 V LIGHT OUTPUT*
To perform the connection see Fig. 32 and consult the relevant instruction
manual.
* Not present in
FILO400SP/AU01 - FILO400ST/AU01 - FILO600SP/AU01 - FILO600ST/AU01

9.9 - INSTALLING THE EXTERNAL RELEASE SYSTEM model KS200KIT

01.
33
2
1
04.
2

9.10 - DIAGNOSTICS AND DEVICE SIGNALS

9.10.1 - Photocell signals

The photocells contain a SAFE led (Fig. 6/A )
SAFE led (Fig. 6/A) Status
O The photocell is not powered or is
faulty
Device not recognised by the control
second pause unit
The RX receives an excellent signal
The RX receives a good signal
The RX receives a poor signal
The RX receives a bad signal
Always lit The RX does not receive any signal
02.
1
2
1
3
Action
ge is correct, the photocell is probably faulty
Repeat the recognition procedure on the control unit. Check that all pairs of pho -
tocells on the ECSBus have di erent addresses (consult the instruction manual of
the photocells)
Normal operation
Normal operation
Normal operation but check TX-RX alignment and correct cleaning of photocell lenses
photocell lenses
Check for any obstruction between TX and RX. Check that the Led on TX emits a
32
Fig. 33 and consult the relevant instruction manual.
03.
3
05.
3
TABLE 7
230 V, 500 W max
2
1
4
5
1
2
Table 7.
English – 14
-