Memorisation Of The Gate Leaf Length (Opening And Closing); Memorisation Of The; St Transmitter - Nice Filo Instructions And Warnings For Installation

16
Aerial A A erial al
L4 L4

5.4 - MEMORISATION OF THE GATE LEAF LENGTH (opening and closing)

After recognition of the devices (Par. 5.3) it is necessary to make the control unit memorise the length of the gate leaf, which is measured from the
01.
02. On the control unit (Fig. 18 ) press and release button P1 wait for the control unit to execute the gate opening manoeuvre up to the opening limit
switch. Only if the manoeuvre is NOT an opening movement
shut o power to the control unit – c) invert the position of the selector on the control unit (Fig. 19) – d) restore power
the learning procedure for the connected devices described in Paragraph 5.3 - MEMORISATION OF CONNECTED DEVICES - f) press and
the P1 key.
03. On the control unit (Fig. 19 ) press and release button P1 wait for the control unit to execute the gate closing manoeuvre up to the closing limit
switch.
18
Aeri al Aerial
04. Lastly, perform various opening and closing manoeuvres while checking that the gate leaf stops at least 2/3 cm from the
both the opening and closing phases (Fig. 20 ). If this distance does not match the proper distance, modify the position of the limit switches.
20

5.5 - MEMORISATION OF THE 1

memorise the 1 st transmitter in Mode 1 – see procedure below.
To memorise additional transmitters, see Par. 9.3.
This procedure allows for simultaneously memorising all the transmitter keys , by automatically pairing them to the commands shown in Table 1 below.
A transmitter memorised in Mode 1 can control only a single automation.
7 – English
Flash Flas h
F use 1. 6A T Fuse 1.6A T
ECSbus E CS bus
Sb
L3 L3 L2 L2 L1 L1
L4 L3 L2 L1
Sb S Sb S
Sb S
P4 P3 P2 P1
P3 P3 P2 P2 P1 P1
Flas h Flash
F use 1. 6A T Fuse 1.6A T
E CS bus ECSbus
L3 3 L2 L2 L1
L4 L 4 L L3 L2 L1
Sb S
Sb S
P4 P4 4 P2 P1
P2 P2 P1
2/3cm
st
TRANSMITTER
17
A e A Aerial
P3 P3
and move the gate to mid-travel so that it is free to move in both the opening and
19
and observe the indicated times.
Flas h Flash
F use 1. 6A T Fuse 1.6A T
OGI OG OGI
ECSbus Sbus
ECSbus
Stop
St Stop
Sb S
L2
P2 P1 P1
to the control unit – e) repeat
F use 1. 6A T Fuse 1.6A T
Aerial Aerial
L 4 L4 L3 L3 L 2 L2
mechanical stops during
2/3cm
release
F la s h Flash
OGI OGI
E CS bus ECSbus
S top Stop
S bS Sb S
L 1 L1
S bS Sb S