Troubleshooting - Nice Filo Instructions And Warnings For Installation

10

TROUBLESHOOTING

Table 12 contains useful information to help solve any malfunctions that may occur during installation or in case of a fault.
Symptoms
The radio transmitter does not emit any signal
and the corresponding Led fails to light up
The manoeuvre fails to start and the
ECSBus led on the control unit does not
The manoeuvre fails to start and the auto
The manoeuvre fails to start and the auto
The manoeuvre starts but is immediately
followed by a reverse run commanded by
the control unit
The manoeuvre is carried out but the
A – English
TABLE 12
Probable cause and possible solution
• Check that the power
cable is correctly inserted in
the power outlet.
have tripped, determine the
cause of the fault and repla -
ce them with others of the
Fig. 34
for model
FILO400C and FILO600C
Fig. 35
for model
F I L O 4 0 0 S T / A U 0 1 a n d
FILO600ST/AU01
* Not present in
F I L O 4 0 0 S P / A U 0 1 a n d
FILO600SP/AU01
- Check that the command is actually received. If the command reaches the SbS input, the rele
- • Check that the Stop input is active (in other words, that the Stop Led is lit). Should this not be
the case, check the device connected to the Stop input.
check the photocells, by verifying their status in Table 7.
obstacles obstructing the gate's movement and, if necessary, select a higher force as described
in Par. 9.1.1.
34
fuse
1A T
35
*
fuse
1.6A T
250 V
V~
11
fuse
3.15A T
fuse
1A T
-