Selecting The Channel(S) For Taking Measurements; Specifying Sensor Settings - Commtest Instruments vb Series Instrument Reference Manual

•
Press
•
Press
and Single.
•
Press
Selecting the Channel(s) for Taking
Measurements
•
From the Set Parameters Menu press
the channel(s) to be used, CH1, CH2 or CH1 & CH2.
If both channels are selected (in vb2000/vb3000), channel 1 data will
be displayed by default. The display can however be toggled
between the channels by pressing
started.

Specifying Sensor Settings

•
From the Set Parameters Menu press
•
Press
Once the desired sensor has been selected:
•
Press
76 Section 4: Manual Setup Measurement Parameters
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
to change the Source between Internal and Tach.
to change the trigger Mode between Free Run
to close this menu and continue.
or to select the sensor to edit.
to edit the Name of the sensor.
to cycle through
once the measurement has