Spanset PowerForce Original Operating Instructions page 23

tional health and safety regulations as well as the regulations of the
professional associations in Germany.
3.4 Intended use
– PowerForce lifting straps are for professional use only. Private use
is prohibited.
– PowerForce lifting straps are slings for hoisting operations only
carry out hoisting operations PowerForce lifting straps are attached
to a hoist, e.g. a crane, and to the load. The actual lifting operation
is carried out with the relevant lifting gear.
– PowerForce lifting straps may only be used in the condition in which
they were sold. Modification of the PowerForce lifting straps is
prohibited.
3.5 Prohibited use
Please find guide illustrations on the reverse of the envelope
covering the following points:
1
Lifting or lowering people or animals
2
Overloading by exceeding the max. load capacity
3
Knot formation
4
Twisting when slinging
5
Using worn or damaged PowerForce lifting straps
6
Tilt angle β larger than 60°
7
Basket hitch
8
Lay the PowerForce lifting strap over crane hook
9
Crushing or overlaying PowerForce lifting straps
10
Placing on to or pulling over sharp edges
(An edge is sharp if the radius r of the edge is less than or equal to
the thickness t of the SpanSet lifting strap) Please observe 4.4.3
Attaching to the load
11
Lay the PowerForce lifting strap on the hook tip of a load hook
12
Remove load from PowerForce lifting straps
1 During lifting operations, loads are raised or lowered through a change in level. When using PowerForce lifting
straps, the height level may only be changed vertically.
21
. To
1
b