Safety Regulations - Spanset PowerForce Original Operating Instructions

Caution! The label A shown on the cover applies exclusively
to the PowerForce lifting strap version in combination with D1
bracket and D2 push-through bracket (PF D1D2)
Label B applies to all other versions (PF HA, PF D1D1 and PF HD).
a. Nominal load-bearing capacity (WLL, Working Load Limit)
b. Raw material
c. Standard used
d. Manufacturer
e. Useful length, lifting strap
f. Item number
g. Name
h. Year of manufacture
i. Traceability code
j. CE marking
k. WLL according to sling type

3 Safety regulations

3.1 Warning labels
Indicates an imminently hazardous situation which, if not
DANGER
avoided, will result in death or serious injury.
3.2 General safety instructions
When handling PowerForce lifting straps, please note the following:
– First check the scope of delivery for completeness and correctness.
– These operating instructions only apply to single-layer PowerForce
loop and endless lifting straps, including permanently connected
fittings. Information should never be taken from other instructions
and used in conjunction with PowerForce lifting straps.
– Only undamaged and original PowerForce lifting straps may be
used.
– The weight, geometry, surface finish and design features of the load
should be determined prior to using the PowerForce lifting straps
and the selection of the strap and the type of strap must be made
according to these criteria (see 4. Use).
– Before each use, pay attention to the information and instructions
19
b