Telnetting To The Unit - ADTRAN Total Access 544R System Manual

DLP-6 Telnetting to the Unit
Introduction
If the Total Access 544R is part of a management cluster connected to the local network, you may use a PC
connected to the network to Telnet into the unit. This procedure details the steps which must be performed
to Telnet into the unit.
Prerequisite Procedures
Complete DLP-4 and DLP-5 (Steps 1 and 2 only).
Tools and Materials Required
• Access to a PC or other computer connected to the LAN.
• VT100 compatible terminal or computer with terminal emulation software
• Appropriate cable to connect terminal to the unit (customer-provided)
• DB-9 female to RJ-45 female adapter for connecting to the
adapter is ADTRAN-proprietary and is provided with the unit.
• Ethernet cable from
• Use Ethernet crossover if going from the unit to a PC (customer-provided).
The A.03.XX firmware supports one Telnet session at a time. The A.04 firmware supports
five simultaneous Telnet sessions.
61200704L2-1B
port on the unit to a hub (customer-provided)
10/100B T
ASE
© 2003 ADTRAN, Inc.
port on the rear of the unit. This
CRAFT
115