ADTRAN Total Access 544R System Manual page 91

Total Access 544R System Manual
.
Step
From the Total Access 544R main menu, select the L2 P
1.
I
2. Select the ATM C
3. Enter the I
4. Set D
Back all the way out to the top level Total Access 544R menu, and then
5.
select the R
From the C
6. WAN.
For basic IP routing, use all the default values.
Select the I
7.
LAN configuration under P
Enter your LAN IP
For this example, the IP
8.
255.255.255.0. Enter the Default Gateway under R
R
Arrow back to the main menu, and select the L2 Protocol Interfaces
9. menu and then the Config > PCV Config menu. Enter your data PVC
information here.
Create a new PVC by entering the menu and press <i> under N
10.
field. Enter your VPI and VCI values.
From the Main Router > Config > Interfaces (SHDSL) > Setup menu,
enter your LAN information.
11.
For this example, the F
N
Arrow back to the top level Total Access 544R menu to activate your
12.
changes.
61200704L2-1B
menu. Set up the ATM network here.
NTERFACES
ONFIG
C format for your network.
DLE ELLS
S appropriately for your network.
ATA CRAMBLING
menu.
OUTER
menu, you will set up addresses for your LAN and
ONFIG
> S
NTERFACE
ADDRESS
.
OUTES
AR
is 255.255.255.252, and the L
ETMASK
© 2003 ADTRAN, Inc.
Section 4 SHDSL RCU ATM User Interface Guide
IP Routing
Action
menu located under the main C
menu, enter the IP menu to enter your
ETUP
IP.
RIMARY
and S M
UBNET ASK
is 192.168.1.2, the S
ADDRESS
E IP is 10.25.4.9, the IP
ND ADDRESS
IP
OCAL
>
ROTOCOL
field.
ONFIG
information.
M is
UBNET ASK
> C >
OUTER ONFIG
UM
is 10.25.4.10.
ADDRESS
91