ADTRAN Total Access 544R System Manual page 110

Section 5 DLP-4
Perform Steps Below in the Order Listed
1. Connect the unit to your VT100 system (details found in DLP-1, Connecting the Terminal or PC to the
CRAFT Port).
2. Log in to the system with maximum rights (details for logging in are in DLP-2 and
DLP-3).
3. From the R /C
OUTER
4. Select the P
RIMARY
Enter the appropriate IP address.
5. From the R /C
OUTER
and press <Enter>.
Enter the appropriate Subnet Mask.
6. From the R /C
OUTER
Enter the appropriate Default Gateway.
7. Escape out to the R
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
110
/I (E
ONFIG NTERFACES TH
IP option and press <Enter>. Select IP A
/I (E
ONFIG NTERFACES TH
/R menu, select the D
ONFIG OUTES
menu and log off by pressing <Ctrl + L>.
OUTER
© 2003 ADTRAN, Inc.
) menu, select the S
ETUP
DDRESS
)/S /P IP menu, select the S
ETUP RIMARY
G
EFAULT ATEWAY
Total Access 544R System Manual
option and press <Enter>.
and press <Enter>.
M
UBNET
option and press <Enter>.
61200704L2-1B
option
ASK