ADTRAN Total Access 544R System Manual page 51

Total Access 544R System Manual
S U > T
YSTEM TILITY
Selecting the terminal mode gives the user a command-line prompt to perform utilities such as pings,
traceroutes, resets, firmware updates, configuration, and more.
using the shortcut keys
• Perform a reset with the command "reset"
• Perform a factory restore with the command "factory_reset"
• Configure the unit. The unit has the ability to download a text file which contains the configuration of
the entire unit. This configuration may then be altered in a text editor, and then uploaded to a unit.
• Debug and troubleshoot. This function would be carried out with the assistance of ADTRAN Technical
Support.
• Start and stop the fail-safe timer for the auto-config feature.
• Perform a firmware upgrade via TFTP.
upgrade_firmware hostname filename
• Use the save command to write the entire configuration to flash.
• Display the unit's MAC address with the command mac
• Perform a ping or extended ping. Syntax is:
ping hostname/address [repeat xx] [size xx] [timeout xx] [source xx] [noNat]
Options:
repeat <repeat count>
size (datagram size)
timeout (seconds)
source (address or name)
noNat
Options may be entered in any order and may be truncated.
Valid interface names are eth0, fdl0, ppp0, fr0, fr1, etc.
Example usage: ping 10.0.0.5 r si 1500 so eth0 n
This will ping with a repeat count of 10. The datagram size is 1500 bytes, and the source address
used in the ping packet will be the ethernet IP address. The "noNat" option has been specified, so
if NAT is enabled, this packet will NOT be translated.
• Perform a traceroute or extended traceroute. Syntax is:
traceroute hostname/address [hops xx] [timeout xx] [retries xx] [source xx] [noNat]
Options:
hops <hops count>
timeout <seconds>
retries <seconds>
source <address or name>
61200704L2-1B
M
ERMINAL ODE
T from other menu screens. From this command-line prompt, you can:
CNTRL
© 2003 ADTRAN, Inc.
Section 4 SHDSL RCU ATM User Interface Guide
T
ERMINAL
Number of pings to send (default 5)
Range is 40-1500
Timeout in seconds (range 1-10)
Source address or interface name to use
Do not NAT the ping packet
Max number of hops (default 30)
Timeout in seconds (default 3)
Number of retries per hop (default 3)
Source address or interface name to use
can also be accessed by
M
ODE
51