ADTRAN Total Access 544R System Manual page 112

Section 5 DLP-5
Perform Steps Below in the Order Listed
1. Ascertain the unit IP address.
If you do not already have the IP Address for the unit, obtain it from the Network Administrator or
manually check for the address in the R
IP/IP A
DDRESS
You must log in with a security level of
parameters on the unit.
2. Ping the unit from a remote computer on the network.
Using a remote computer system connected to the LAN, perform an ICMP Ping on the IP Address of
the unit. Verify that the unit responds properly.
If the unit fails to respond, try the following:
• Verify that the proper IP Address, Subnet Mask, and Default Gateway are provisioned in the unit
(see DLP-4, Setting Ethernet IP Parametersfor details).
• Verify that the unit is properly cabled into the LAN and that the Ethernet cable is properly seated
in the RJ-45
10/100B
• Verify the LAN link light on the front of the unit is lit. If not lit, check the cabling between the hub
and the unit.
• If the unit is connected to a hub or other network device that provides a carrier sense light for each
port, verify that the carrier sense light for the port to which the unit is connected is lit. If this light
is not lit, check the cabling between the hub and the unit.
• Verify the IP Address, Subnet Mask, and Default Gateway on the remote computer system.
• Use Ethernet straight-through cable for connection to hub or switch. Use Ethernet crossover if
connecting to a PC.
If none of these steps are successful, contact the LAN Administrator for assistance.
Refer to the documentation of the computer system if you are unsure how to perform a Ping
command. Most computers running a networked version of Microsoft Windows™ or UNIX
allow a Ping to be performed by simply typing ping <IP Address> at a command line
prompt. Typically, the Ping program will respond by indicating that the remote IP Address
has responded in a certain amount of time or that no response was received.
Some versions of Ping will continue running until you explicitly tell them to stop. If the
program does not terminate on its own, type
112
OUTER
menu.
port on the rear of the unit.
T
ASE
© 2003 ADTRAN, Inc.
Total Access 544R System Manual
/C /I
ONFIG NTERFACES
, , or
C S F
ONFIG UPPORT
to get the program to stop.
<Ctrl+C>
(E )/S /P
TH ETUP RIMARY
to modify the IP
ULL
61200704L2-1B