ADTRAN Total Access 544R System Manual page 35

Total Access 544R System Manual
Security Description
Level
Full The user has all access to view and configure all menus (same as logging in to
the CRAFT port)
Support The user has read only access to view the S
privileges to view and change everything under the S
except for the CRAFT port settings, telnet access lists, and the SNMP
management communities. The user has full access to the S
menu, including the ability to upgrade firmware and reset the unit. The user has
full access to the I
The user does not have the ability to set R
S
ECURITY
Config The same privileges as support, except that the user does not have privileges to
download firmware or configuration from the S
additionally does not have the privilege to reset the unit remotely, or enter the
terminal menu.
Router The user has read only privileges for the S
to the S
the S
status from the I
R
OUTER
Voice The user has read only privileges for the S
access to the P
The user has full access to the FXS module from the I
Status The user has read access of all menus except for the following: S
C
ONFIG
M
to U
user cannot reset the unit or enter terminal mode.
S C > M
YSTEM ONFIG
Set up the list of allowed telnet managers.
N A
ETWORK DDRESS AND
Enter a network address and subnet mask from which telnet access to the unit is allowed. When a
remote unit requests telnet access to the unit, if the access list is empty or the remote's IP address
matches a list entry, remote access is granted. A subnet mask of 0.0.0.0 will allow any host telnet
access, regardless of the network address. A network address of 0.0.0.0 with corresponding netmask
255.255.255.255 will not allow any host telnet access.
The factory default is
61200704L2-1B
Table 2. Telnet Security Levels
NTERFACES
menu.
C menu. The user has P
YSTEM ONFIG
U menu. The user is limited to ethernet configuration and
YSTEM TILITY
NTERFACES
menus. Access is limited to filters only from the S
and T
ING
/CRAFT P , S
ORT YSTEM
, and S
ANAGEMENT ECURITY
F , U
PGRADE IRMWARE
> T
ANAGEMENT ELNET
M
ASK
for both parameters, which will allow all users telnet IP access.
0.0.0.0.
© 2003 ADTRAN, Inc.
Section 4 SHDSL RCU ATM User Interface Guide
YSTEM
, L2 P , B
ROTOCOL RIDGE
ADIUS SERVER
YSTEM
YSTEM
ING
menu. The user has full access to the B
YSTEM
utilities from the S
RACEROUTE
C /T A
ONFIG ELNET
/ R S . The user does not have access
ADIUS ERVER
C , P , or T
PGRADE ONFIG ING
A > IP A
CCESS CCESS
I menu. The user has
NFO
C menu
YSTEM ONFIG
U
YSTEM TILITY
, R , and DS0 menus.
OUTER
settings under the
U menu. The user
TILITY
I menu. There is no access
NFO
and T access from
RACEROUTE
RIDGE
menu.
ECURITY
I menu. The user has
NFO
U menu.
YSTEM TILITIES
menu.
NTERFACES
YSTEM
, S C
CCESS YSTEM ONFIG
menus. The
RACEROUTE
L
IST
and
/SNMP
35