External Sensor - Panasonic KX-TDA30 Features Manual
Hybrid ip-pbx
Hide thumbs
Also See for KX-TDA30:
- Features manual (472 pages) ,
- Installation manual (428 pages) ,
- User manual (258 pages)
Table of Contents
Advertisement
1.16 Optional Device Features
1.16.7 External Sensor
Description
External sensing devices, such as security alarms or smoke detectors, can be connected to the PBX. When
the PBX receives input from a sensor, a call is made to the preset destination, alerting the extension user.
The available destinations of a sensor call are as follows:
[Available Destinations]
Wired Extension (PT/SLT/ISDN Extension/T1-OPX)
PS
Incoming Call Distribution Group
PS Ring Group
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analogue/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Other PBX Extension (TIE with no PBX Code)
Other PBX Extension (TIE with PBX Code)
When the call is answered, a special dial tone is heard, which continues until the user goes on-hook. If the
sensor call is not answered within a specified time, the call will be cancelled. It is possible to set a different
ring tone pattern for calls received from each external sensor, to distinguish between them.
Conditions
•
Hardware Requirement:
KX-TDA30: An external sensor and the DPH card
KX-TDA100/KX-TDA200: An external sensor, the OPB card and EIO card
•
Some devices may be unable to communicate correctly with the PBX. Confirm compatibility with the
manufacturer of a device before installing it.
•
After a sensor has been activated, the PBX will ignore any further alerts from the same sensor for the
duration specified by a timer. This timer can be set separately for each sensor.
•
As long as the previous sensor call is still being performed, any further alerts from the same sensor are
ignored.
•
The assigned sensor name and/or number are shown on the display of PTs and PSs when a sensor
call is received.
•
If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside
party), the call will be received at the original destination. (→ 1.3.1.2 Call Forwarding (FWD))
164
Feature Guide
Destination
Availability
Advertisement
Table of Contents
