1.9.4 Drill Chuck Protection; Prohibition, Warning And Mandatory Signs; Safety Check - Optimum OPTIdrill B 40GSP Operating Manual

1.9.4 Drill chuck protection

Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that
the cover is closed.
INFORMATION
You cannot start the machine if the drill
chuck protection is not closed.
1.9.5

Prohibition, warning and mandatory signs

INFORMATION
All warning signs must be legible. Check them regularly.
1.10

Safety check

Check the geared drill before each start-up or at least once per shift. Inform the person respon-
sible immediately of any damage, defect or change in operating function.
Check all safety devices

at the beginning of each shift (with the machine stopped),

once a week (with the machine in operation),

after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the geared drill

are legible (clean them, if necessary),

are complete (replace if necessary).
INFORMATION
Use the following table in order to organize the checks.
General check
Equipment
Protective covers
Signs,
Markings
Date:
EN B40 GSP
14
Integrated position
Clamping screw
Drill chuck protection
Check
Mounted, firmly bolted and not damaged
Installed and legible
checked by (signature):
Translation of original instruction
switch
Img.1-5: Drill chuck protection
OK
Safety
Version 2.1.1 - 2020-07-27