During Work - Optimum OPTIdrill B 40GSP Operating Manual

Please make sure to use a suitable dust suction when treating wood since wood dust may be
health hazardous.
Wear a suitable dust mask when performing works at which dust is generated.

First, select the speed of the bit. This will depend on the diameter of the bit being used and

on the material.
4.7.2

During work

The spindle sleeve is advanced by means of the star wheel. Make sure that the feed is constant
and not too fast.
The spindle sleeve is returned to its initial position by the return spring.
WARNING!
Seizing of clothes and / or hair.

Make sure to wear well-fitting work during drilling work.

Do not use gloves.

If necessary, use a hairnet.
CAUTION!
Danger of bumps from the levers on the star wheel.
Do not release the star wheel when repositioning the drilling spindle sleeve.
Pull back the drilling spindle sleeve by hand.
CAUTION!
Danger of crushing. Do not place your hand between the drilling head and the spindle
sleeve.
INFORMATION
The smaller the bit the more easily it may break.
In the case of deep drilling, remove the bit from time to time to remove filings from the drill. Add
a few drops of oil to reduce friction and prolong the service life of the bit.
EN B40 GSP
34
Determining the cutting speed and the speed on page 35
Translation of original instruction
Handling
Version 2.1.1 - 2020-07-27