Working With The Machine; Preparation - Optimum OPTIdrill B 40GSP Operating Manual

Img.4-9: Filler hole
Img.4-10: Coolant shut-off tap and doser

Adjust the flow using the shut-off and dosing tap.
ATTENTION!
Failure of the pump in case of dry running.
The pump is lubricated by the cooling agent. Do not start up the pump without cooling
agent.
CAUTION!
Danger of injury due to brushes getting caught or pulled in.
Use a spray gun or a washing bottle for cooling.
INFORMATION
Use a water-soluble and non-pollutant drilling emulsion as a cooling agent.This can be acquired
from authorised distributors.
Make sure that the cooling agent is being collected.
Respect the environment when disposing of any lubricants and coolants.
Follow the manufacturer's disposal instructions.
4.7

Working with the machine

4.7.1

Preparation

WARNING!
For drilling jobs, it is necessary to clamp the workpiece firmly to prevent the bit catching
on the pieces. A machine vice or clamping claws is a suitable clamping device.
Put a wooden or plastic board beneath the workpiece to avoid drilling through to the work table,
vice, etc.
If necessary, adjust the required drilling depth using the depth stop to obtain a constant result.
Handling
Version 2.1.1 - 2020-07-27
Coolant charging hole
Coolant shut-off tap and doser
Translation of original instruction
B40 GSP EN
33