ADJ 1.8.1 Entrance Drive Panel Position Adjustment
This drive panel controls the nip forces of N2, N3, N4 and N5.
1. To adjust the position of the drive panel loosen (5) screws from the
Front frame and (5) screws from the rear frame.
2. Using the Reference holes in the front/rear frame (5 holes in the front
frame and 5 holes in the rear frame) and the sheet metal panel,
position the drive panel to ensure the drive rollers protrude
1.5±0.5mm through the drive panel.
GBC AdvancedPunch Pro
08/20/2015
4-139
Repairs/Adjustments