GBC AdvancedPunch Pro Service Manual page 150

13. Remove the Drive Roller.
Drive Roller.
Repairs/Adjustments
Installation Procedure
1. Place the Drive Roller in position.
2. Install the Ball Bearing at the rear side of the Shaft.
3. Install the Ball Bearing and the Washer at the front side of the Shaft.
4. Install the E-Ring at the front side of the Shaft
5. Install the Washer and the E-Ring at the rear side of the Shaft.
6. Slide the Pulley on to the Roller Shaft.
7. Place the Belt over the Pulley.
8. Install the retaining ring on the Drive Roller N5.
9. Move the Tensioner of the M2 motor belt into position and tighten the
Screws (2).
10. Adjust the Belt Tension, ADJ 1.7.4
11. Do REP 3.1 to install the Punch Module.
12. Do REP 1.6 to install the Rear Cover.
13. Close the Front Door.
14. Connect the Power Cord.
15. Power ON the entire printing system.
08/20/2015
4-62
GBC AdvancedPunch Pro