GBC AdvancedPunch Pro Service Manual page 178

10. Place the Bearing Bracket in position and tighten the Screws (2).
11. Place the Ball Bearing in position.
12. Place the Nylon Washer in position.
13. Place the E-Ring in position.
NOTE: The tension on the Belt is set using the reference marks on
the punch motor bracket (see REP 3.2).
14. Do REP 1.6 to install the Rear Cover.
15. Connect the Power Cord.
16. Power ON the entire printing system.
Repairs/Adjustments
Mark
08/20/2015
4-90
GBC AdvancedPunch Pro