GBC AdvancedPunch Pro Service Manual page 199

10. Remove the E-Ring from the Shaft at the rear of the Punch Module.
11. Remove the E-Ring from the Shaft at the front of the Punch Module.
12. Pull the Shaft out through the Cams (2) and out of the Punch Module.
Installation Procedure
1. Place a Die Lock Cam inside the Punch Module by the hole at the
front of the Punch Module (cam portin against side Frame).
2. Insert the Die Lock Shaft through the hole at the front of the Punch
Module and through the hole in the Cam.
3. Push the Shaft through the Punch Module, through the hole in the
other Cam, and out through the hole in the rear of the front of the
Punch Module (cam portin against side Frame)
4. Insert the E-Ring on the Shaft at the front of the Punch Module.
GBC AdvancedPunch Pro
E-Ring
E-Ring
Shaft
5. Insert the E-Ring on the Shaft at the rear of the Punch Module.
6. Insert the Socket Head Cap Screw and Split Lock Washer into the
Cam and the Shaft at the front of the Punch Module.
7. Insert the Phillips Screw into the Cam and the Shaft at the rear of the
Punch Module.
8. Insert the Shoulder Screw the hole in the Shaft at the rear of the
Punch Module. Make sure it is in the correct phase (Shoulder Screw
facing down as well as Cam Screws facing down).
9. Place a Lock Nut on each of the M4X25 Phillips Head Pan Screws
(2), then insert the Screws into the holes in rear of the Punch Module.
10. Tighten the Screws (2) until they are flush with the Nut inside the
Punch Module.
11. Place the Punch Module in an upright position.
12. Do REP 3.1 to install the Punch Module.
13. Insert the Die Lock Handle into the Shaft at the front of the Punch
Module, and tighten the Screw.
14. Install the Die Set (see Operator Manual).
15. Do REP 1.6 to install the Rear Cover.
16. Connect the Power Cord.
17. Power ON the entire printing system.
08/20/2015
4-111
Repairs/Adjustments