GBC AdvancedPunch Pro Service Manual page 133

Installation Procedure
1. Place the Bearing Housings (2) on the ends of the Idler Roller Shaft.
2. Place the new Idler Roller with the Bearing Housings (2) into the
Bushing Forks.
3. Make sure the flat surface of the bushing aligns in the fork.
4. Rollers are non-directional so it does not matter which end goes in
each fork.
5. After the assembly is in place, gently pull the assembly outward and
release to ensure it moves freely in the fork.
6. Place the Extension Spring (2) over the Bearing Housings (2).
7. Place the hooks on the ends of the Extension Springs (2) on the
notches at the top of the Bushing Forks (2).
8. Do the following to install the covers.

For the Idler Rollers in the Exit Idler Panel, do do REP 1.8 to
remove the Upstream Side Frame Cover.

For the Idler Rollers in the Acceleration Roller Idler Assembly, do
REP 1.8 to remove the Upstream Side Frame Cover.

For the Idler Rollers in the Exit Idler Panel, do REP 1.11 to install
the Downstream Rear Side Cover.

For the Idler Rollers in the Bypass Panel, lower the Bypass Panel
and close the Front Door.
9. Connect the Power Cord.
10. Power ON the entire printing system.
GBC AdvancedPunch Pro
08/20/2015
4-45
Repairs/Adjustments