Table of Contents
Advertisement
Installation Procedure
1. Place the new Die Rail Assembly in position.
2. Place the Chip Chute in position and tighten the Nuts (3).
3. Place the Springs (2) in position, install the M2 Lock Washers (4), and
tighten the the M2 Screws (4).
4. Install all brackets from both sides.
5. Place the the Die Rail Assembly in position.
6. Install and tighten the Screws (4) that hold that Die Rail Assembly.
When installing (4) screws that hold the die rail, use 3mm reference
holes for positioning the part. A 3mm pin can be inserted to hold the
part in position while the screws are tightened.
7. Tighten the Screws (2) that hold the Dieset Recognition Bracket.
8. Connect the Alignment Sensor Board and place the wires in the
Cable Clamps.
9. Connect the Back Gage Sensor Board and place the wires in the
Cable Clamps.
10. Do REP 3.1 to install the Punch Module.
11. Do REP 1.6 to install the Rear Cover.
12. Install the Die Set (see Operator Manual).
13. Connect the Power Cord.
14. Power ON the entire printing system.
Repairs/Adjustments
08/20/2015
4-114
GBC AdvancedPunch Pro
- Quick Links:
- Parts List
Hide quick links:
Advertisement
Chapters
Table of Contents
