GBC AdvancedPunch Pro Service Manual page 126

Installation Procedure
1. Place the Drive Exit Panel in position.
2. Install the new Drive exit panel, by installing the (4) screws in the front
frame and (4) screws in the rear frame.
3. Do ADJ 1.8 Drive Panel Position Adjustment
4. Place the Timing Belt Tensioner Assembly of Motor M6 in position
and tighten the (2) nuts.
5. Do REP 2.23 to install Motor M7.
6. Place the Bracket in position in Area 5 of the machine, and tighten the
(3) M4 nuts.
7. Do REP 2.6 to install the Exit Idler Panel.
8. Do REP 2.5 to install the Punch Lower Exit Panel.
9. Do ADJ 1.7 Idler Panel Magnetic Latches Adjustment.
10. Do REP 1.11 Downstream Side Frame Cover Replacement install the
Downstream Side Frame Cover.
11. Do GP 6.4 to dock the Punch to the upstream and downstream
equipment.
12. Connect the Power Cord.
13. Power ON the entire printing system.
Repairs/Adjustments 08/20/2015
4-38
GBC AdvancedPunch Pro