GBC AdvancedPunch Pro Service Manual page 125

REP 2.7 Drive Exit Panel Replacement
PARTS LIST ON PL 3.1
Use this procedure to remove and install the Drive Exit Panel.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do GP 6.4 to undock the Punch from the upstream and downstream
equipment.
4. Do REP 1.11 Downstream Side Frame Cover Replacement remove
the Downstream Side Frame Cover.
5. Do REP 2.5 to remove the Punch Lower Exit Panel.
6. Do REP 2.6 to remove the Exit Idler Panel.
7. Remove (3) M4 nuts to remove the Bracket in Area 5 of the machine.
GBC AdvancedPunch Pro
8. Do REP 2.23 to remove Motor M7 by removing (4) screws.
9. Remove the Timing Belt Tensioner Assembly of Motor M6 by
removing (2) nuts.
10. Remove (4) screws from the front frame and (4) screws from the rear
frame to remove the Drive Exit Panel.
11. Remove the Drive Exit Panel.
08/20/2015
4-37
Repairs/Adjustments