GBC AdvancedPunch Pro Service Manual page 205

10. For DFA configurations- remove (2) M4 screws of the left side die
rack.
11. For DFA configurarations- Tilt the Power Supply and remove it
through the Chip Tray opening. The die rack (loosened in the above
step) has to bend up slightly to give room for the Power supply to be
removed.
12. Transfer all wires to the new Power Supply.
GBC AdvancedPunch Pro
Installation Procedure
1. Reverse Steps for Installation.
08/20/2015
4-117
Repairs/Adjustments