Altering A Programme; Allocating Wash Blocks - Miele PG 8583 CD Operating Instructions Manual

Programme settings
Allocating wash
blocks
102

Altering a programme

You can alter all parameters which are identified as changeable in the
programme charts. Other settings can only be altered by Miele
Service.
A programme setting is altered in two steps:
- First the wash blocks must be reallocated to the programme or the
existing allocation confirmed again. Only allocated programme
blocks can be parameterised.
- Then the programme parameters can be altered.
Use this option to document all changes to factory settings in case
of a subsequent Service call requirement.
Changing programme parameters on a validated machine will
necessitate a renewed performance validation.
...
Programme settings

Change programme

Change programme
Select the programme you want to alter.

For more information see "Allocating wash blocks".
For every programme change the wash blocks must first be allocated.
Universal
Allocation is by multiple choice. A box is shown next to all wash
blocks in the display. If a wash block is allocated to the programme,
there is a tick  in the box. This wash block is allocated to the
programme by ticking the box or the allocation can be removed by
removing the tick.
The wash blocks can be selected or deselected using the  and 

arrow buttons and confirming with OK.
To save the selection select the

and confirm with OK.
If you want to adopt the preset wash blocks without any changes,

you can confirm the
The further setting options will then follow. You can edit these in any
order you want.
Universal
Standard
Accept
Pre-wash 1
Accept
Accept
option immediately with OK.
option at the end of the list