Steam condenser
Protective foil/
Worktop
protector
Preventing heat
build-up
Securing to the
worktop
Venting the
circulation pump
Building under a continuous worktop
To avoid steam damage to the worktop the protective foil supplied
(25 x 58 cm, self-adhesive) must be applied underneath the
worktop in the area of the steam condenser.
The protective foil supplied protects the worktop from damage
caused by steam when the door is opened. It should be positioned
underneath the worktop above the machine door.
During the drying phase, the hot exhaust air from the wash cabinet is
released into the surrounding environment through the steam
condenser at the rear of the machine. Sufficient ventilation must be
ensured to prevent heat build-up and excessive condensation.
Leave a minimum distance of 10 mm for air exchange between the
machine and the worktop.
If necessary ventilation grilles should be fitted in the side units.
To improve stability the machine must be secured to the worktop
after it has been aligned.
Open the door.
Screw the machine to the continuous worktop through the holes in
the front trim on the left and right.
Please contact the Miele Customer Service Department to secure it
at the sides to adjacent cabinetry.
The gaps between a built-in machine and adjacent cabinetry
must not be sealed, e.g. with silicone sealant, as this could
compromise ventilation of the circulation pump.
Installation
155