Electrical Connection; Equipotential Bonding Connection - Miele PG 8583 CD Operating Instructions Manual

 All electrical work must be carried out by a suitably qualified
electrician in accordance with local and national safety regulations.
- The electrical installation must comply with current local and
national safety regulations (DIN VDE 0100 in Germany).
- The connection to the power supply must be via a suitably rated
plug and socket and must comply with national regulations. The
socket must be accessible after the machine has been installed. An
electrical safety test must be carried out after installation and after
any maintenance work.
- If the machine is hard-wired to the power supply, a power switch
with all-pole isolation must be installed. The power switch must be
designed to operate at the rated current for the machine, must
ensure a 3 mm gap between all open contacts, and must be able to
be locked in the off position.
- Equipotential bonding should be carried out if required.
- The rated loads are specified on the data plate and in the circuit
diagram supplied with the machine.
- For increased safety, it is recommended to protect the machine
with a suitable residual current device (RCD) with a trip current of
30 mA.
- If replacing the power cable, use only original replacement parts
from the manufacturer or a suitable cable with core cable ends.
Further notes on electrical connection are given on the Installation
diagram supplied with the machine.
The machine must only be operated with the voltage, frequency and
fusing shown on the data plate.
Depending on country this machine can be converted to a different
type of power supply in accordance with the conversion diagram
and wiring diagram supplied.
A data plate can be found on the inside of the door and another on
the back of the machine.
The wiring diagram is supplied with the machine.

Equipotential bonding connection

There is a screw connection point marked  at the back of the
machine, to which additional equipotential bonding can be connected
if required.

Electrical connection

157