Drying Unit - Miele PG 8583 CD Operating Instructions Manual

Drying unit

Cooling down
pause
The additional "Drying" function accelerates the drying process at the
end of the programme.
When the drying function is activated and the door is closed, the
drying system feeds heated and HEPA-filtered air into the wash
cabinet for active drying of the load. The heated air is discharged
through the steam condenser and can be cooled down if necessary
(see "Further settings/Air cooling").
A cooling down pause can be inserted between the end of the final
rinse phase and starting of the drying system. During this pause,
water vapour is extracted from the wash cabinet and condensed by
the steam condenser. This reduces the moisture level in the wash
cabinet, which promotes drying.
...
Cooling down pause

Cooling down pause
No
Time
- No
The drying unit starts immediately after the rinse phase without a
cooling down pause.
- Time
The cooling down pause is activated for a duration which can be
set.
Select an option using the  and  arrow buttons and confirm your

selection with OK.
Time
When has been selected, the duration of the cooling down
pause must then be set.
The setting value is entered in increments of 10 seconds. The
possible range is shown in the bottom line of the display.
Use the arrow buttons  (higher) and  (lower) to set the duration

of the cooling down pause.
Press OK to save the setting.

Cooling down pause
120 s
(0 - 600 s )
Programme settings
113