Install Wheels; Install Steering Wheel; Install Front Fenders; Install Rops - Toro Workman 3100 Operator's Manual

Install Wheels

1. Remove and discard fasteners securing wheels.
2. Mount wheels and torque nuts to 55–75 ft-lb.
1
Figure 1
1. Wheel

Install Steering Wheel

1. Remove jam nut from steering shaft. Slide foam seal,
steering wheel and washer onto steering shaft.
2. Secure steering wheel to shaft with jam nut and tighten
it to 10–15 ft-lb.
3. Install cap to steering wheel.
5
Figure 2
1. Steering wheel
2. Jam nut
3. Cap
2
2. Wheel nut
4
3
2
1
4. Washer
5. Foam seal
15

Install Front Fenders

1. Mount a fender to each side of skirt with (7) 10–24
Phillips screws, flat washers and locknuts.
Figure 3
1. Fender

Install ROPS

1. Insert each side of ROPS into mounting bracket on each
side of vehicle frame, positioning ROPS as shown in
figure 4.
2. Secure each side of ROPS to mounting brackets with
(2) 1/2–13 x 3" lg. capscrews and locknuts.
FRONT
Figure 4
1. ROPS
1
1
2
2. Mounting bracket