Capturing A Photo; Setting The White Balance; Changing The Settings - Atmos iQam Operating Instructions Manual

Pausing a recording
1. Pause the recording via the button in the software.
» The status indicator flashes red.
» Two red vertical bars appear in the live image.
4.7

Capturing a photo

1. Launch the software.
2. Tap 2 x on the status indicator (to use this function the tab mode must be
activated and the video recording must be selected as a function for the
mode, see "4.9 Changing the settings" on page 15).
» The photo is taken.
» The status indicator lights up blue briefly.
» The camera vibrates 2x.
 You can also start and stop the video recording via the software or a foot
switch.
4.8

Setting the white balance

 Do not set the white balance under fluorescent light because otherwise the
result may not be satisfactory.
1. Launch the software.
2. Turn on the light source and wait until the light has stabilized.
3. If possible, carry out the white balance under natural lighting conditions.
Otherwise, use a white-gray surface.
4. Open the window camera settings
5. Click the white balance button.
4.9

Changing the settings

You need the ATMOS Capture Suite software to use these functions. Observe the
operating instructions for the ATMOS Capture Suite software.
.
15
Operation