Fcc Compliance; Eu Declaration Of Conformity - ETC ArcSystem Pro D1 Series Installation Manual

ETC Installation Guide
D1 & D2 Series Drivers
CAUTION:
To reduce the risk of electric shock, disconnect both the branch circuit-breakers or
fuses and emergency power supplies before servicing.
ATTENTION :
d'alimentation. Pour réduire le risque d'électrocution, débranchez les disjoncteurs
de dérivation ou les fusibles et les alimentations de secours avant de procéder à
l'entretien.
Test the ArcSystem emergency system as described:
1. Turn off power at the normal circuit breaker.
2. Test the system per ANSI/NFPA 101 Life Safety Code.
Compliance
For current and complete compliance information, view the product datasheets at
etcconnect.com/ArcSystem.
FCC Compliance
Wireless-capable ArcSystem products comply with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including interference that may cause
undesired operation.
ArcSystem wireless products contain FCC ID for US: TYOJN5168M5 and Industry Canada (IC) ID:
IC 7438A CYO5168M5.
Note:
the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense.
EU Declaration of Conformity
Wireless-capable ArcSystem products comply with the essential requirements of the RED Directive
of the European Union (2014/53/UE).
Wireless-capable ArcSystem products also comply with the following standards:
ETSI EN 301 489-17 V2.1.1 (2009), ETSI EN 301 489-1 V2.2.0 (2011), Draft ETSI EN 301 489-17
V3.2.0 (2017), Draft EN 301 489-1 V3.2.0 (2017), ETSI EN 300 328 V1.8.1 (2012), ETSI EN 300 328
V1.9.1 (2015), ETSI EN 300 328 V2.1.1 (2016)
D1 & D2 Series Drivers
This equipment has more than one power supply connection point.
Cet équipement possède plusieurs points de connexion
Wireless-capable ArcSystem products have been tested and found to comply with
Page 25 of 25 ETC