Towing The Machine - Toro Groundsmaster e3200 Operator's Manual

Figure 36
1. Charger port
7. Insert the wall-plug end of the power-supply
cord into a grounded electrical outlet.
For power source requirements, refer to
Understanding Power Source Requirements
(page 39).
8. Observe the display screen to ensure that the
batteries are charging.
Note:
The display screen shows the battery
amperage and charge status
Figure 37
9. Disconnect the chargers when the machine
reaches a sufficient level; refer to
the Charging Process (page
g386076
2. Charger-port cover
(Figure 37).
g469312
Completing
40).
Completing the Charging Process
1. Remove the power-supply cord from the
machine charger port.
2. Place the power-supply cord in a storage
position that avoids damage.
3. Start the machine and verify the charge level
using the display screen.
When charging is complete, the display screen
shows 10 solid bars.

Towing the Machine

The electric parking brake automatically engages
when the machine in is neutral or if the machine
experiences a power outage. You must disengage the
electric brake (located under the operator's platform)
via the display screen or with a lever to allow the
machine to be towed.
1. Chock both sides of the front tires.
2. Perform one of the following steps to disengage
the parking brake:
•
If the machine has electrical power, turn
on Tow Mode in the display screen Service
menu.
Note:
The electric parking brake disengages
when you turn on Tow Mode and the machine
can move freely when you remove the chocks
from the tires.
If you press the traction pedal, Tow Mode
disengages and the parking brake functions
normally.
•
If the machine does not have electrical
power, perform the following steps to
manually release the parking brake:
A. Remove the lever from the operator's
manual tube.
B. Use the lever from the operator's manual
tube to loosen the nut on the platform
frame
40
(Figure 38).