Setup; Adjusting The Machine Settings; Mounting The Battery Charger On A Wall; Charging The Batteries - Toro Revolution Series Operator's Manual

Setup

Adjusting the Machine
Settings
Use the InfoCenter to adjust the machine settings;
refer to InfoCenter Display (page
Mounting the Battery
Charger on a Wall
Optional
You can mount the charger on a wall using the
wall-mount key holes cut into the back of the unit. Use
screws that have a 6 mm (1/4 inch) diameter shaft
and a head diameter of 11 mm (0.45 inch).
Important:
Survey your work area and determine
a location that best meets the criteria for safe and
effective operation of the charger.

Charging the Batteries

Check the battery-system charge; charge them as
needed. Refer to Monitoring the Battery-System
Charge Level (page 30).
14).
13

Product Overview

1. Deck-lift pedal
2. Height-of-cut positions
3. Transport-lock lever
4. Control panel
5. Motion-control lever

Controls

Become familiar with all the controls before you start
and operate the machine.
Control Panel
1. Key switch
2. Power-takeoff switch
(PTO)
Figure 4
6. Roll bar
7. Mower deck
8. Caster wheel
9. Anti-scalp roller
Figure 5
3. Light switch
4. InfoCenter
g397211
g396030