Slide-Out Manual Override Procedure - PREVOST H3-45 VIP Owner's Manual

is activated. The following actions will be done in
sequence:
Deflation of the inflatable seal
l
Movement of the slide-out to its full "OUT"
l
position
Then releasing the rocker switch will permit the
following actions:
Re-inflation of the seal
l
When the rocker switch is released, the green
indicator light goes out. Note that for safety reasons,
releasing the rocker switch will stop the slide-out
movement instantly. At any time, releasing the
rocker switch from the "OUT" position and pressing
it to the "IN" position will reverse the operation.
CAUTION
The inflatable seals can be re-inflated only when
the slide-out is in its full "OUT" or full "IN" position.
Do not leave the slide-out in any position other than
the full extended or closed position as water
infiltration may occur. The indicator light on the
control pad must be OFF.
NOTE
A green blinking light on the control pad indicates
an error condition or missing operation condition on
the corresponding slide-out. Refer
TROUBLESHOOTING" on page 36
ation occurs.
to"SLIDE-OUT
if that situ-
PA-1638 Owner's Manual X3-45 VIP
SLIDE-OUT CONTROL PAD
Slide-out Retracting Operation
With the ignition switch to the "ON" position and the
engine running, press and hold down the rocker
switch to the "IN" position to retract the slide-out.
Note that the green indicator light "ROOM IN
OPERATION" will come on. When the movement of
the slide-out to its full "IN" position is completed, the
rocker switch can be released to allow the re-inflation
of the seal. The green indicator light goes out as the
rocker switch is released. At any time during the
slide-out movement, releasing the rocker switch will
stop the operation instantly.
CAUTION
The inflatable seals can be re-inflated only when
the slide-out is in its full "OUT" or full "IN" position.
Do not leave the slide-out in any position other than
the full extended or closed position as water
infiltration may occur.

SLIDE-OUT MANUAL OVERRIDE PROCEDURE

CAUTION
Never use an impact power tool to manually
operate the slide-out. Doing so would damage the
various mechanical components of the slide-out.
Do not over extend or over retract the slide-outs.
Always refer to the slide- out decal for correct
direction of rotation (clockwise or counter
clockwise).
In case of power retracting system failure, it is
possible to use the manual override procedure to
retract or extend the slide-out.
The manual override procedure consist in rotating the
slide- out motor shaft extension using a cordless
power drill with a 3/8" hexagonal bit.
Other Features 5-33