Keyless Operating Instructions; Programming And Managing Personal Codes - PREVOST H3-45 VIP Owner's Manual

5-30 Other Features

KEYLESS OPERATING INSTRUCTIONS

Entering a valid access code enables secure
operation. After entering the access code, the
keypad is enabled for 5 seconds and a fifth button
press initiate an action.
NOTE
A double beep after entering an access code
indicates a correct code and readiness for an
action command.
To Unlock The Entrance Door And Disarm The
Anti-theft System:
Enter your personal or the default access
l
code followed within 5 seconds by the 1/2
key.
To Unlock The Baggage And Service Com-
partment Doors:
Enter your personal or the default access
l
code followed within 5 seconds by the 5/6
key.
To Unlock All Doors Simultaneously:
Enter your personal or the default access
l
code followed within 5 seconds by the 3/4
key.
To Lock The Doors And Activate The Anti-theft
System:
NOTE
The lock function will not function when the ignition
is in the ON position or the entry door is open.
NOTE
After repeated attempts to enter codes (20 button
presses without enabling), the keypad will enter in
an inactive mode that disables buttons for 60
seconds. The lock indicator will flash amber and
red during this state.
If a partial validation code is entered or no action
button is pressed within 5 seconds, the keypad will
revert back to disabled condition and the access
code will have to be entered again.
PROGRAMMING AND MANAGING PERSONAL
CODES
It is possible to program up to 40 four (4) digit
personal access codes to unlock the entrance door
and compartments. These codes do not replace the
default code that is factory supplied with the vehicle.
When programming codes, do not choose codes that
present the numbers in sequential order, studies
show that people who idly press the buttons usually
press a sequential pattern. Also, do not select a code
that uses the same button four times, thieves can
easily figure out these types of codes.
To Add A New Personal Code:
NOTE
- If the 40 codes memory is already full, a long
beep will be heard.
- At any time, press the 9/0 key to exit
programming mode.
PA-1638 Owner's Manual X3-45 VIP
Press the 9/0 key for 2 seconds (no access
l
code required).
Choose and memorize a four (4) digit personal
l
code.
Press and hold the 5/6 key for five seconds
l
(keypad will start to beep and flash).
Enter the vehicle factory six (6) digit authority
l
code.
Press the 1/2 key (a short beep will be heard,
l
validating the action).