PREVOST H3-45 VIP Owner's Manual page 141

PNEUMATIC CONTROL PANEL
NOTE
Refer to the slide-out decal for correct direction of
rotation (clockwise or counter clockwise).
3. To move the slide-out, use a cordless power
drill with a 3/8" hexagonal bit on the shaft
extension of the slide-out motor.
4. Rotate the slide- out motor shaft extension
with the power drill until the slide-out comes
to its closed position.
5. Once the slide- out room is lined up to its
closed position, remove the tool from the
motor.
NOTE
The front slide-out motor is located inside the 2nd
baggage compartment while the rear slide- out
motor is accessible from inside the vehicle, under
the bed structure.
SLIDE-OUT MOTOR MANUAL ACTIVATION
Slow down on the closing speed as the slide-out
approaches its closed position. As soon as the "in
limit" stoppers come in contact with their bearing
surface, stop immediately the power drill rotating
movement. Not doing so could overload the drive
mechanism and cause damage to the reduction
gearbox.
INFLATABLE SEAL PRESSURE GAGE
NOTE
The slide-out control system inhibits transmission
range selection to prevent the vehicle from moving
if the slide-out is not in its full "IN" position.
Manual Extending Procedure – Front And Rear
Slide-out
The pressure in the inflatable seal must be
completely relieved to prevent any damage to the
seal.
PA-1638 Owner's Manual X3-45 VIP
Other Features 5-35
CAUTION
6. Finally, the inflatable seal can be re-inflated
by turning the shut- off
counterclockwise. Check the pressure gage
on the inflatable seal regulator to see if the
pressure is increasing to around 15 psi.
Needle should point between the green
indicator pegs.
1. Apply barking brake to disengage the security
pin from the receptacle.
2. Turn the ignition switch to the "OFF" position,
and remove the ignition key for more safety.
3. Deflate the inflatable seal by using the
relieving shut-off valve located in the slide-out
control panel. Turn the handle clockwise to
deflate the seal. Make sure the pressure
indicator reading is "0 psi".
CAUTION
valve handle