Other Precautions - PREVOST H3-45 VIP Owner's Manual

If another vehicle is following close behind,
l
reduce your speed to let the vehicle pass.
For additional
l
operation and defensive driving practices,
contact the local department of motor
vehicles authority.

OTHER PRECAUTIONS

WARNING
CALIFORNIA PROPOSITION 65
Diesel engine exhaust
constituents are known to the State of California to
cause cancer, birth defects and other reproductive
harm.
Battery posts, terminals
accessories contain lead and lead compounds,
chemical known to the State of California to cause
cancer and other reproductive harm.
Batteries also contain other chemicals known to
the State of California to cause cancer.
Wash hands after handling.
DANGER
Make sure that electrical current or air pressure is
removed before performing any work. A part may
be energized even if the ignition switch is OFF. A
part may be under pressure even if all tanks are
empty. Before performing any work on the vehicle,
refer to wiring diagrams and/or air schematics to
thoroughly understand the system.
information about safe
and some of its
and other related
PA-1638 Owner's Manual X3-45 VIP
Safety Precautions 1-3
NOTE
When the ignition switch is set to the OFF position,
the electrical components are not energized except
for the MCM (Master Chassis Module), the battery
equalizer, the preheater system and some
electronic modules; which are energized during 15
minutes after the ignition has been set to the OFF
position. Prior to working on one of these electrical
components, set the battery master switch in the
main power compartment to the OFF position. If
the vehicle will not be operated for a long period
(more than 2 weeks), it is recommended, in order
to prevent the batteries from discharging, to trip the
main circuit breakers located in the main power
compartment to stop the small current drawn by
the radio preset station memory, the MCM memory
and the instrument cluster clock. Note that the
radio station presets will be erased, same thing for
the diagnostic codes history and the instrument
cluster clock will have to be reset.
CAUTION
PRECAUTIONS ARE TO BE OBSERVED
BEFORE WELDING TO MINIMIZE THE RISK
OF MAJOR AND COSTLY DAMAGES CAUSED
TO THE VEHICLE ELECTRONIC
COMPONENTS!
1. Set the battery master switch to "OFF"
position.
2. Trip circuit breaker CB2 and CB6.
3. Disconnect electronic ground terminal from
the ground junction block located in the
battery compartment.
4. Make sure to clamp the welding ground
return as close as possible to the welding
point and make a good electric contact to
the chassis.
Detailed instructions are provided in section 00-
GENERAL of your vehicle maintenance manual.