Tire Pressure Monitoring System - PREVOST H3-45 VIP Owner's Manual

7-4 Safety Features and Equipment
6. The system must be reset and the fire
extinguisher removed
accordance with the System Reset portion of
the Kidde Dual Spectrum Operation &
Maintenance Manual.
Starting The Vehicle After A Fire Alarm
The vehicle may be started after a fire alarm without
resetting the system. Refer to ignition switch
sequence below. This will not reset the system;
rather it will instruct the vehicle's multiplex system to
ignore vehicle interface outputs from the Protection
Panel. This feature is intended to be used only in
emergencies that require the vehicle to be restarted
and moved a short distance prior to system reset. It
should not be performed if the cause of the fire has
not been clearly identified and corrected.
To start the vehicle, perform this ignition switch (key)
sequence.
From the ON position,
l
Turn to OFF , return to ON and START
l
vehicle within 2 seconds.

TIRE PRESSURE MONITORING SYSTEM

The vehicle may be equipped with an optional Tire
Pressure Monitoring System (TPMS).
and replaced in
PA-1638 Owner's Manual X3-45 VIP
Description
System includes the following elements:
Special tire valves;
l
RF sensor inside each tire, fixed to the valve.
l
Sensors provide continuous tire pressure and
temperature reading. The normal sensor
battery lifespan is 5 years. The remaining
lifespan is displayed as a percentage in the
TPMS display;
3 antennas to receive the sensors RF signal
l
(one in the front spare tire compartment, one
above the L.H. side rear wheels and one
above the R.H. side rear wheels);
A TPMS receiver connected to the antennas
l
and located
compartment, above the CECM;
A TPMS display built in the L.H. dashboard
l
panel (with On-Screen TPMS version);
A "Tire Pressure Warning" indicator.
l
NOTE
It is recommended to check the remaining battery
lifespan when changing the tires in order to replace
the sensors at the same time if they are due for
replacement before the next change.
The telltale panel indicator illuminates for 3 seconds
when the ignition switch is turned ON to check the
display operation and the communication between
the display and the vehicle multiplex system. This
confirms the communication between the TPMS
display and CECM.
Setting The On-Screen TPMS
Set Wheel ID
l
in the front electrical