Preparing A Storage System That Does Not Have An Svp; Changing The Default Password; Step 6: Perform The Initial Setup - Hitachi VSP F370 System Installation

Step 6: Perform the initial setup

Initial setup of the storage system is performed using the Windows-based management
console.

Preparing a storage system that does not have an SVP

Before you begin
Confirm that the Windows-based management console has an Internet connection and
an installed version of one of the following web browsers: Internet Explorer version 11 or
later, Chrome, or Firefox.
Procedure
1. Connect the management port on controller 1 and controller 2 to a management
(non-production) network.
2. Configure the management console to use an IP address of 192.168.0.18 and a
subnet mask of 255.255.255.0.
Next steps
Change the storage system's default password.

Changing the default password

To prevent unauthorized access to your storage system, change the default password.
Procedure
1. On your management console PC or laptop, open a web browser and enter the
following IP address: 192.168.0.16
2. Enter the default user name maintenance and the default password raid-
maintenance, and then press the Enter key to log in to Hitachi Storage Advisor
Embedded.
Installing your storage system
Storage system installation (without SVP)
Step 6: Perform the initial setup
16