The Displayed Bypass Tray Paper Size Is Not Correct; The Original Misfeeds (Automatic Document Feeder) - Sharp MX-M502N Operation Manual

Problem
The displayed bypass
tray paper size is not
correct.
PROBLEMS RELATED TO PAPER FEEDING AND
OUTPUT
Problem
The original misfeeds
(automatic document
feeder).
Point to check
Is the bypass tray extension pulled out?
Point to check
Is too much paper loaded in document
feeder tray?
Is the original a long original?
Is the original on thin paper?
Is the feed roller dirty?
Pull out the bypass tray extension.
When loading paper in the bypass tray, be sure to pull
out the extension to enable the paper size to be
detected correctly.
Make sure that the stack of paper in the tray is not
higher than the indicator line.
When using the automatic document feeder to scan
a long original, set the scan size to [Long Size].
(Note that long originals cannot be copied using the
copy function.)
Use the document glass to scan the original.
If you need to use the automatic document feeder, use
slow scan mode in the special modes to scan the
original.
Clean the surface of the original feed roller.
☞
1. BEFORE USING THE MACHINE
"MAINTENANCE" (page 1-66)
8-51
TROUBLESHOOTING
Solution
Solution
Contents