The Displayed Bypass Tray Paper Size Is Not Correct; Problems Related To Paper Feeding And Output; The Original Misfeeds; The Paper Misfeeds - Sharp MX-2300G Troubleshooting Manual

Problem
The displayed bypass
tray paper size is not
correct.

Problems Related to Paper Feeding and Output

Problem

The original misfeeds.

The paper misfeeds.

30
Point to check
Is the bypass tray extension pulled out?
Point to check
Is the original on thin paper?
(When the automatic document feeder
is used.)
Is the feed roller dirty?
Is a torn piece of paper remaining in the
machine?
Is too much paper loaded in the tray?
Are multiple sheets feeding at once?
Are you using paper that is not within
the specifications?
Has the paper in the tray absorbed
moisture?
Are the bypass tray guides adjusted to
the width of the paper?
Is the bypass tray extension pulled out?
Is the bypass tray feed roller dirty?
Solution
When loading paper in the bypass tray, be sure to pull
out the extension to enable the paper size to be
detected correctly.
☞
Illustration of the machine (H) (page 36)
Solution
Use the document glass to scan the original. If you need
to use the automatic document feeder, use slow scan
mode in the special modes to scan the original.
Clean the surface of the original feed roller.
☞
"5. MAINTENANCE" in the User's Guide
Make sure all paper is removed.
☞
REMOVING MISFEEDS (page 3)
Make sure that the stack of paper in the tray is not
higher than the indicator line.
☞
Illustration of the machine (E) (page 36)
Fan the paper well before loading it.
Use SHARP-recommended paper. Using paper that is not
supported may result in misfeeds, creases, or smudges.
☞
"SUPPLIES" in the Safety Guide
* For paper that is prohibited or not recommended, see
"USEABLE PAPER" in the User's Guide.
If you will not be using paper in a tray for a long time,
remove the paper from the tray and store it in a bag in a
dark and dry location.
Adjust the bypass tray guides to the width of the paper.
☞
Illustration of the machine (F) (page 36)
When loading a large size of paper, pull out the
extension.
☞
Illustration of the machine (H) (page 36)
Clean the surface of the bypass tray feed roller.
☞
"5. MAINTENANCE" in the User's Guide