Part Names And Functions; Exterior - Sharp MX-M502N Operation Manual

BEFORE USING THE MACHINE
This section provides basic information about the machine. Please read this chapter before using the machine.

PART NAMES AND FUNCTIONS

EXTERIOR

(1)
(1) Document cover*
Place an original on the document glass and close the
document cover before copying starts.
(2) Automatic document feeder
This automatically feeds and scans multiple originals. Both
sides of 2-sided originals can be automatically scanned.
☞
PLACING THE ORIGINAL
(3) Front cover
Open this cover to switch the main power switch to "On"
or "Off" or to replace a toner cartridge.
☞
TURNING THE POWER ON AND OFF
☞
REPLACING THE TONER CARTRIDGES
(page 1-69)
(4) Paper pass unit*
This transfers output to the finisher (large stacker) or
saddle stitch finisher.
* Peripheral device.
(2) (3) (4)
*
(page 1-38)
(page 1-15)
1-3
BEFORE USING THE MACHINE
(5) (6)
When a finisher / saddle stitch
finisher is not installed
When a finisher is installed
(5) Operation panel
This is used to select functions and enter the number of
copies.
☞
OPERATION PANEL
(6) Exit tray unit (right tray)
When installed, output can be delivered to this tray.
(7) Output tray (centre tray)
Output is delivered to this tray.
(8) Finisher*
This can be used to staple output. A punch module can
also be installed to punch holes in output.
☞
FINISHER (page 1-44)
(7)
(8)
(page 1-8)
*
Contents