Siemens LMV27.100x2 Basic Documentation page 178

To the next curvepoint
A
and
or
To the next curvepoint
178/219
Building Technologies
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic Documentation LMV27...
26 Parameter level
Curvepoint P2 can only be adjusted when
symbol or
Fuel valve V2 will be switched on.
Keep depressed.
A
Press or
%
When symbol
highlighted, the next curvepoint P2of can be
selected with
Curvepoint P2of is now adjusted.
The LMV27 remains at P2.
Adjust the switch-off point with no travel.
Now, the curvepoint is approached
dynamically when traveling from P2 to P1.
%
When symbol
highlighted, the next curvepoint P1 can be
selected with
Automatic mode will be released when, after
reaching P1, the curve settings are quit with
ESC.
If the settings are aborted earlier (ESC or
shutdown due to fault), start prevention OFF
%
UPr is still active until all curvepoints are set.
ESC
When symbol
highlighted, ESC can be pressed a second
time.
%
Back to the previous
curvepoint.
is no longer highlighted.
to adjust the value.
or is no longer
.
Back to the previous
curvepoint.
or is no longer
.
Back to the previous
curvepoint.
or is no longer
CC1P7541en
17.12.2018