Radio Configuration - Raven RS1 Calibration And Operation Manual

RADIO CONFIGURATION

FIGURE 22. Radio Link Screen
Connection Point. Calibrates the RS Lite for the types of radio data to transmit and receive during autonomous
operation.
Radio Channel. Set the radio channel for autonomous vehicle operations. The radio channel may be set between
1 and 18 and must be set to the same value for each vehicle operating as part of the autonomous system.
Interference on channels will vary by location and other radio communication in the area. If too much interference
is present, the system may encounter frequent communication or link errors. If this occurs, change the radio
channel for each radio in the system to find a channel with less interference.
Radio Tx (Transmit) Power. The radio signal power to transmit to other radios in the autonomous system. The
value must be between 10 and 30.
Lower values typically offer better results for near proximity (e.g. syncing with the combine, smaller fields, etc.).
Higher values may be required to transmit across larger fields or through tree lines, but may cause more
interference when machines are operating close together.
Non-Controlling Combine Present. Use the drop down list to set the number of non-controlling combines
present during field operations.
NOTE: The value set for the number of non-controlling combines present must be set on the Radio Link tab
on each machine in the AutoCart system (e.g. the tractor, the controlling combine, and each non-
controlling combine).
016-4010-001 Rev. F
SLINGSHOT
87