C
3
HAPTER
FIGURE 6. Antenna Fore/Aft Screen
5. Select the value box to enter the Antenna Fore/Aft position.
NOTE:
The Antenna Fore/Aft position is calculated by measuring from the rear axle of the machine to the
middle of the RS1 unit. Enter a negative value if the RS1 unit is located behind the rear axle.
6. Select the Next arrow.
FIGURE 7. Antenna Center Offset Screen
7. Select the value box to enter the Antenna Center Offset position.
NOTE:
The Antenna Center Offset position is calculated by measuring from the center of the machine to the
center of the RS1 unit. Enter a negative value if the RS1 unit is located to the left of the machine center
line.
8. Select the Next arrow.
10
Raven RS1™ and RS Lite™ Calibration and Operation Manual