Error Codes - Kyocera ECOSYS M2135dn Service Manual

7-6 Error codes

Scan to PC (SMB/FTP/Email) transmission error codes, contents, checkpoints and remedies are
described.
The error code not listed here may be the software failure.
Turn the power switch off then on, and execute again.
(1) Scan to SMB error code
Codes
1101
The destination host does not exist in
the network.
1102
Login to the destination host has failed.
1103
The destination host, destination folder
and file are invalid.
1105
The SMB protocol is not valid.
2101
Connection to the destination host has
failed.
2201
Scanned data writing has failed.
2203
No response from the destination host
more than the specified time
Content
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA
Check method and remedy
1. Check the destination host name.
2. Check the network setting of the device.
3. Check the network setting connecting to the device.
1. Check user name and password.
2. Check the network setting connecting to the device.
3. Check sharing settings of the destination host and
folder.
1. Check if invalid characters are included in the desti-
nation host name, destination folder or file name.
2. Check if the destination folder name and file name
conform with the naming syntax.
3. Check the destination host and destination folder.
1. Check the SMB protocol setting of the device.
1. Check the destination host name.
2. Check if the LAN cable is connected to the device.
3. Check the SMB port number.
4. Check the network setting of the device.
5. Check the network setting connecting to the device.
1. Check the transmission file name.
2. Check the network setting of the device.
3. Check the network setting connecting to the device.
1. Check the network setting connecting to the device.
2. Check if the LAN cable is connected to the device.
7-84