Kyocera ECOSYS M2135dn Service Manual page 311

Error codes
Codes
00
Automatic adjustment success
01
Black band detection error
(Table scanning leading edge skew in the
sub-scanning direction)
04
Black band is not detected (Table leading
edge in the sub-scanning direction)
05
Black band is not detected (Table far end in
the main scanning direction)
06
Black band is not detected (Table near end
in the main scanning direction)
07
Black band is not detected (Table trailing
edge in the sub-scanning direction)
08
Black band is not detected (DP far end in
the main scanning direction)
09
Black band is not detected (DP near end in
the main scanning direction)
0a
Black band is not detected (DP leading
edge in the sub-scanning direction)
0b
Black band is not detected
(Original check of DP leading edge in the
sub-scanning direction)
0c
Black band is not detected (DP trailing
edge in the sub-scanning direction)
0d
White band is not detected (DP trailing
edge in the sub-scanning direction)
0e
DMA time out
0f
Magnification error in the sub-scanning
direction
10
Leading edge error in the sub-scanning
direction
11
Trailing edge error in the sub-scanning
direction
12
DP skew error in the sub-scanning direc-
tion
13
Maintenance request error
14
Center line error in the main scanning
direction
15
DP skew error in the main scanning direc-
tion
16
Magnification error in the main scanning
direction
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA
Contents
6-56
Corrective action
-
1. Set the original correctly and
execute the adjustment again.
2. Check lighting of the lamp or
replace it.
1. Check the attachment position of
DP.
2. Check lighting of the lamp or
replace it.
3. Check the back and front of the
adjustment original.
Turn the power switch off then on,
and execute again.
1. Turn the power switch off then
on, and execute again.
2. Adjust manually.
(U065 to U067, U070 to U072)
Turn the power switch off then on,
and execute again.
1. Turn the power off and on, and
execute again.
2. Adjust manually.
(U065 to U067, U070 to U072)