Kyocera ECOSYS M2135dn Service Manual page 327

U610 System 1
(Message: System Setting 1)
Contents
Set the number of lines to be ignored when receiving a fax at 100% magnification and in the auto
reduction mode.
Method
1.Press the [Start] key.
2.Select the item to set.
Items
Cut Line: A4
Cut Line: 100%
Cut Line: Auto
Setting: Cut Line: A4
Set the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode onto A4R or Letter R paper.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the
entire data on a page is further reduced so that it can be recorded on the same page.
1.Press the [◄] [►] keys or the numeric keys to change the counter value.
Number of lines to be ignored when receiving in the A4R
auto reduction mode.
* :Increase the setting value if a page received in the reduction mode is reduced too much with
the trailing edge margin. Decrease the value if there is dropout in received image.
2.Press the [Start] key to set the setting value.
Setting: Cut Line(100%)
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when recording the data at 100% magnification.
If the number of excess lines is below the setting, those lines are ignored. If it is over the setting,
they are recorded on the next page.
1.Press the [◄] [►] keys or the numeric keys to change the counter value.
Set the number of lines to be ignored when receiving a fax
at 100% magnification.
* :Increase the setting value if a blank second page is output in the full magnification reception.
Decrease the value if there is dropout in received image.
2.Press the [Start] key to set the setting value.
Set the number of lines to be ignored when receiving a fax (A4R/Let-
terR) in the auto reduction mode.
Set the number of lines to be ignored when receiving a fax at 100%
magnification.
Number of lines to be ignored when receiving in the auto reduction
mode.
Contents
Contents
6-72
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA
Contents
Setting Initial
range setting
0 to 22
Setting Initial
range setting
0 to 22
Data
varia-
tion
0 -
Data
varia-
tion
3 -