Shut Down The Generator; Dc Operation; Connecting The Battery Charging Cable - Energizer EZG Series User Manual

6.2 SHUT DOWN THE GENERATOR:

Once the generator is no longer needed it can be shut down:
(1). Disconnect or turn off all electrical loads connected to the
generator AC Receptacles 1.
(2). Turn the Engine Switch 3 to "STOP" position.
(4). Allow the engine to cool well.
Always allow the generator to cool off before moving or storing.
High temperatures will be present at the rear of the unit for
some time after shutdown.
<<27>>

7. DC OPERATION

Never smoke, open flame sparks or make and break connections
at the battery while charging. Sparks may ignite the battery gas.
Batteries give off explosive hydrogen gas while recharging.
Provide adequate ventilation when charging or using batteries.
Wear protective goggles and gloves when working around a
battery. Battery electrolyte is an extremely corrosive sulfuric acid
solution that can cause severe burns. Avoid contact with skin,
eyes or clothing. If a spill occurs, flush area with clear water
immediately.

7.1 CONNECTING THE BATTERY CHARGING CABLE:

CHARGING CABLE
(1). Before connecting the Battery Charging Cable to a battery that is installed
in a vehicle, disconnect the vehicle battery ground cable from the negative (-)
battery terminal.
(2). Plug the Battery Charging Cable 1 into the 12V DC 5A Receptacle of the
generator.
<<28>>